The BevAlert Model 8900 provides direct measurement of Acetaldehyde, Benzene, Toluene, Ethylbenzene, and Xylenes (ABTEX) in Carbon Dioxide. The instrument is utilized by Specialty Gas Manufacturers and the Food and Beverage Industry to monitor trace volatile organic compounds in CO2 used in carbonated beverages.

Read More

The Series 8900 BTEX Analyzer provides direct measurement of Benzene, Toluene, Ethylbenzene, and Xylenes in ambient air. This instrument is utilized in ambient air networks around metropolitan areas and fence-line monitoring at industrial sites.

Read More

The PetroAlert Model 8900 combines the selectivity of gas chromatography with the sensitivity, broad dynamic range, and hydrocarbon selectivity of a flame ionization detector (FID) providing a 30 second analysis of C1-C5 hydrocarbons required in Mud Logging for Oil & Gas exploration, while maintaining C1-C2 separation at 200:1 concentration ratios.

Read More

The Series 8900 Hydrogen Sulfide and Carbon Disulfide Analyzer provides direct measurement of H2S and CS2 in ambient air. This instrument is utilized for continuous emission monitoring.

The Series 8900 H2S and CS2 Analyzer employs a Photoionization detector (PID) as the sensing element. A dual column configuration with timed backflush to vent is used to strip off moisture and heavier
hydrocarbons.

Read More

In order to drill a successful oil well, most drilling operators will use a good drilling fluid or mud (figure 1).
Mud cools and lubricates the drilling tool, helps to attack the rock by injection under pressure, and cleans out the hole, carrying away the pieces of crushed rock. These mud systems are usually WBM (Water-Based Mud), OBM (Oil-Based Mud) or SOBM (Synthetic Oil-Based Mud).

Read More

Some industries require strict control of particle size and particle shape in order to manufacture high quality products. These industries can benefit from the use of a particle size analyzer that can also perform shape analysis This document describes measurement made on plate particles used in paint industry. The shape of the particles is of first importance for the paint industries in order to have good shades. Two samples having the same thickness with two different surface must be controlled after production.

Read More

The requirement for accurate thickness measurements is found across many industries including aerospace, oil and gas, pharmaceutical and food processing.  Either for quality control in manufacturing or in-service verification often access is only available from one side and speed is critical.  The wall thickness from most materials can be measured ultrasonically including metals, composites, plastics and glass using a simple hand-held digital gauge.

Read More